Glass Art Forums » General Discussion

**Taurus 3 Saw** Posted: 6/6/2009 8:57:57 PM

I am looking at purchasing a taurus saw 3 to make those intricate cuts. Has anyone used one of these saws? I have been told that they cut too slow and the blades break easily. Any information would be appreciated.

**Re: Taurus 3 Saw** Posted: 6/13/2009 7:59:08 PM

Hi there:)

Well, I have been using it for some time and I have had a good time using it...

However, the saw is not for thicker pieces but fine for glass no thicker then one inch or so...

Regards ...

Glass Art Forums » General Discussion

Taurus 3 Saw

Post Reply to: Taurus 3 Saw